Yes, there is a good news that you can save your money despite paying for the installation of heating ducts and insulating pipes. Not just your money can be saved but also you can contribute to the environment by conserving the energy.
You can insulate the pipe and ducts run in the unwanted areas of the homes as a conserving measure for the saving of energy and cost. If you will not insulate these ducts and pipes, then your money will be wasted because the heat will not be transferred to the areas you are wanting heat to travel, instead it will move to unwanted areas. Make an important note that never place your pipe insulation or ducts within the three feet of exhaust flues, heating system or other areas with higher temperature.
For insulation, you may install fibreglass with foil backed or vinyl duct insulation for supplying heating to ducts systems. You can even opt for fibreglass insulation with regular face that is not very expensive and even has the higher R value. Do you know what is R-value? The measure of the capability for retarding the heat flow. The insulation will be better with the higher number.
For determining the amount of insulation that you need, firstly take the measurement of the distance around every section of the duct and then multiply it with the overall length. You can order for 30% greater than the amount that is accounted for the calculation to fasten the overlaps that are needed.
Make sure for sealing all of the air leaks in your duct system with the high temperature caulks like silicone and duct tapes, before the insulation. Then, cover the insulated supply ducts and finally, secure them using the clinch type staples, preferably, tape or wire even. Despite duct tapes are installed much conveniently but they are not long lasting like the staples. The duct should be completely wrapped and overlapped. The insulation’s backing must be at the outside of the surface. All the joints as well as the exposed fibreglass between the insulation’s pieces must be under covering with taping.
Ducted heating installation Melbourne must be done with proper care to avoid leakages. Control handles that are damper must be available in operable and easily accessible positions. The labels which might be available on ducts, should be surely transferred outside of insulation. The return ducts need not to be insulated.